Chapter 2 Installation and Setup
TDP-324
-17-
The direction
which inserts
a shaft
5.
Take out the new plate from the black
polybag.
6.
Change the flange(gear side) position of
the spool according to the size of the plate
to be used.
Please refer to "2.9 The change method of flange position."
7.
Insert the shaft of the spool into the core of
the plate and gently force the flange(gear
side) of the spool on the side of the plate.
[Useful tip]
When inserting the shaft of the spool into the core of the plate, place the
plate so that the lead edge of the winding plate is upward. Then, insert the
shaft of the spool from the right-hand side.
As the outer diameter of the flange is larger than the outer diameter of the
plate, it is recommended that this work is performed with the right-hand side
of the plate protruding from the work table.
Spool
(Flange(gear side))
Plate
Work table
The plate weighs approx. 10 kg(22 lbs).
Handle it carefully so as not to drop it.
Dropping it is dangerous.
Flange(gear side)
Lead edge of the winding plate
Summary of Contents for TDP-324
