![background image](http://html1.mh-extra.com/html/mitsubishi/vs-sh10u/vs-sh10u_setup-and-installation-manual_1809617035.webp)
VS-SH10U Set-up and Installation Manual
35
3.4.3. White balance adjustment
NOTE: In principle, this adjustment is unnecessary because the luminance/tint level
between each screen of the multi screen is adjusted in CSC adjustment. However,
adjust the white balance to change the color temperature or adjust finely after CSC
adjustment.
[Input signal] Built-in test signal: Adjustment white (See “Test pattern display” on page 16: press
TEST
TEST
TEST
TEST
button once)
To display the monochrome color, press
R
R
R
R
G
G
G
G
B
B
B
B
in the remote control unit.
[Adjustment]
1. Select SET WHITE BALANCE in service menu (See “Service menu” on page 20) and select
from among HIGH, MIDDLE, and LOW.
2. Adjust R, G and B GAIN.
White balance adjustment display
3.4.4.
Gradation adjustment
NOTE: In principle, this adjustment is unnecessary because the luminance/tint level
between each screen of the multi screen is adjusted in CSC adjustment. Be careful
not to deteriorate the uniformity in a screen.
[Input signal] Built-in test signal: Adjustment white (See “Test pattern display” on page 16: press
TEST
TEST
TEST
TEST
button once)
[Adjustment]
1. Select R/G/B-GRADATION in service menu (See “Service menu” on page 20).
2. Compensate differences of luminance/tint level between each screen in red, green and blue.
Be careful about uniformity in a screen.
3. Add finishing on the fringe of screens to harmonize with the whole multi vision system.
Notice:
W-GRADATION adjustment is usually unnecessary unless R/G/B-GRADATION adjustment is
doing well.
Each adjustment should be in an adequate range. Adjustment value should be stayed within the
confines of –50 to 50, even though whole range is –128 to 127.
WHITE BALANCE M
R-GAIN
1000
G-GAIN
1000
B-GAIN
1000
Summary of Contents for VS-SH10U
Page 1: ...DLPTM Projector VS SH10U Set up and Installation Manual August 30 2002...
Page 8: ...First edition 8 1 2 Outline drawings 1 2 1 Circuit Box unit mm...
Page 9: ...VS SH10U Set up and Installation Manual 9 1 2 2 Optical Unit unit mm...
Page 56: ...First edition 56 6 2 6 axis adjuster Model Screw holes VS SH10U c e h j...