Edge 2 – User Manual
MIXTILE
- 12 -
V1.3
Copyright
©
2022 MIXTILE.
MIPI-DSI
The MIPI-DSI display supports two channel DSI and 2.5Gbps maximum data rate per lane. It
supports up to 1920x1080@60Hz display output for single-MIPI mode and 2560x1440@60Hz
for dual-MIPI mode. Two MIPI-DIS interfaces use 30-pin FPC connectors,
MIPI-DSI0 and
MIPI-DSI1, which include one channel MIPI-DSI and one touch panel signal (TP).
The connectivity is shown in the following figure:
MIPI-DSI Architecture
1.5.11 U.2 Connector
The U.2 interface uses a 68-pin U.2 connector including a standard SATA signal, which supports 5V
at 3A maximum, a SATA 3.0/PCIe 2.0 signal, a USB 2.0 signal, and another set of RGMII for
ethernet.
1.5.12 Buttons & LEDs
The POWER button controls three statuses of the device, on, off, and sleep. Short press POWER
button to turn on device when the device is off, press and hold POWER button to turn off device.
Short press POWER button to enter sleep mode when the device is on. Short press RESET button to
reset the device. When the device is on, press the RECOVERY button and hold, it will restart and
restore the factory settings.
The MASKROM button is for development only, hold the MASKROM button and power up (or reset).
The system will enter MaskROM mode for firmware development.
The power and system LEDs indicate the statuses of the power supply and system operating. And
two small LEDs on the front side of board indicate the network status of M.2 and mini-PCIe modules.
