IPB-5000A
1. Special Precautions
1-4
(2) Precautions for Handling
Install the Power Supply on a firm and level surface. If it is used inclined or on its
side, it may have a malfunction.
Also, provide 10 cm clearance to the intake and exhaust for improving the effect of
heat release (Refer to
5. (1)Installation
).
Do not install this Power Supply in the following places:
▪
Where there is considerably damp (humidity is 90% or higher).
▪
Where the ambient temperature is above 40
℃
or below 5
℃
.
▪
Where there is nearby high-frequency noise source.
▪
Where the Power Supply may be exposed to chemicals.
▪
Where moisture may be condensed on the surface of the Power Supply.
▪
Where there is considerable dirt.
▪
Where the Power Supply may be subjected to vibration or impact.
If the outside of the Power Supply is stained, wipe it with a dry cloth or a
moistened cloth. If it is badly stained, use diluted neutral detergent or alcohol to
clean it. Do not use paint thinner, benzene, etc., which can discolor or deform the
parts.
Do not put screws, coins, etc., in the Power Supply, as they may cause a
malfunction.
Operate the Power Supply according to the method described in this operation
manual.
Operate the switches and buttons carefully by hand. If they are operated roughly
or with the tip of a screwdriver, a pen, etc. they may be broken.
Operate the switches and buttons one at a time.
If two or more of them are operated at a time, the Power Supply may have trouble
or may be broken.
