Rev: June 27, 2013 Page 11 of 21
Increase Sensitivity
- Tap this button to increase the sensitivity of the Lightning
Bug™. When this button is pressed, the bargraph display (orange LED’s) will be
show the current sensitivity level. There are a total of 26 levels of available
sensitivity**. The factory default setting is level 12.
Determining the Current Sensitivity Level -
The orange LEDs on the top of the
Lightning Bug
TM
will always display the current sensitivity level when the unit is
powered on, 1 being the least sensitive, and 26 being the highest. See Table 1 for
more details.
Displayed Information -
The orange LED display reflects the current sensitivity
level, or when in FPS adjust mode, the frames per second (see Table 1, LED Bar
graph Display). When adjusting the sensitivity, all the LED’s to the leftmost side
will illuminate to allow easier visualization of the setting. Within approximately 1
second of no further adjustments, the display will return to the normal display
mode, showing the current sensitivity setting.
The yellow LED (shaped like a lightning bolt) illuminates whenever the unit has
detected an event and has tripped the shutter. When adjusting the FPS, this LED
flashes at a rate of approximately 2 times per second.
Table 1: LED Bar graph Display:
Normal (low power) Display:
Displayed while making adjustments:
Summary of Contents for Lightning Bug
Page 1: ......