Camera system
messtechnik
EMC Test and Measuring Systems
mk
Extended Manual
Clicking button „R“
[3]
rescans the PC for available COM ports and refreshes the list.
If Auto Connection (Auto Con.)
[7]
is checked, the software will try to connect to the last successful connected
receiver (USB or LAN) immediately after the software starts. You don‘t have to click on „Connect“.
Checking the „Connection test“
[8]
(Conn. test) periodically checks, if the receiver is still connected.
4.2.2.2 Network
Figure 4-3: Options for the connection with the receiver over Network
Using LAN you can connect up to eight PCs to one receiver. Enter the correct IP address of the receiver into field
[2]
. The network settings of the receiver can be configured on tab „Configuration“, see chapter 4.3.9.3. The port
cannot be changed and is only displayed here for information, so that you can unblock it on your PC or in your
external firewall. Whether this is required, depends on the topology of your local network.
You can also assign your own meaningful names to IP addresses (see chapter 4.4.2). Addresses entered in the field
[2]
will be saved permanently and can be easily selected again.
To establish the connection, click on button „Connect“
[5]
.
To close the connection, click on button „Disconnect“
[6]
.
If Auto Connection (Auto Con.)
[7]
is checked, the software will try to connect to the last successful connected
receiver (USB or LAN) immediately after the software starts. You don‘t have to click on „Connect“.
Checking the „Connection test“
[8]
(Conn. test) periodically checks, if the receiver is still connected.
4.2.2.3 Notes
As long as the PC is not connected to the receiver, most of the functions of the software are not available
and are
displayed as disabled (see figure 4-1). In addition some pages show the information, that no camera has been
selected yet, since this can only be done after a successful connection.
4.2.3 Connection Successful
After a succesful connection some fields are disabled, so that connection settings can not accidently be changed
during runtime.
To connect again, the established connection has to be disconnected first.
Page 14 / 43
Distributed by: Reliant EMC LLC, 3311 Lewis Ave, Signal Hill CA 90755, 4089165750, www.reliantemc.com
