Camera system
messtechnik
EMC Test and Measuring Systems
mk
Extended Manual
4.3.1 Camera Control
Figure 4-5: Control functions of the camera
These buttons correspond to the hardware buttons of camera and receiver and are described in more detail there
(see base manual).
4.3.2 Pan/Tilt Control
Figure 4-6: Control functions of the pan/tilt unit
These buttons move a pan/tilt unit and correspond to the hardware buttons of the receiver. They are described in
more detail there (see base manual).
With these buttons
[1]
the user can set or delete the user contollable limits of the pan/tilt unit. Clicking a button
sets the actual pan/tilt position as limit (control turns green) or deletes the limit (control turns gray). To enable the
setting of the limits, the Button „Limit“ has to be clicked first (the grey limit markers will get a black border). Click
the button again to disable the setting of the limits again.
Button
[2]
reads all status data from the pan/tilt unit again. This can be neccessary, if someone changed the limits
at the pan/tilt unit directly, which will not be sent to the PC automatically.
Button
[3]
will enable the controlling of the pan/tilt unit even if the camera could not detect the pan/tilt unit,
Page 16 / 43
Distributed by: Reliant EMC LLC, 3311 Lewis Ave, Signal Hill CA 90755, 4089165750, www.reliantemc.com
