Camera system
messtechnik
EMC Test and Measuring Systems
mk
Extended Manual
which can happen with older hardware.
4.3.3 Saving and Restoring the Actual Pan/Tilt Unit Position and Camera Zoom
Figure 4-7: Saving and restoring of the positions
With these control elements the zoom position and the position of both pan/tilt axes can be saved to disk, to be
restored later.
4.3.3.1 Saving
To save a position, provide a meaningful name in input field
[1]
. Then press button
[2]
.
4.3.3.2 Restoring
To restore a saved position, select the desired data record from the list
[1]
. After clicking on button
[4]
the camera
will zoom to the saved position. With button
[5]
you can restore the saved position of the pan/tilt units axes.
i
When moving a pan/tilt unit automatically, the currently set limits will be taken into account,
so that it can happen, that the pan/tilt unit will stop moving before reaching the desired
position.
Please refer to the base manuel for additional information regarding limits of a pan/tilt unit.
4.3.3.3 Deleting
To delete a saved position, select it from the list and press button „Delete“
[3]
.
4.3.3.4 Zoom Slider
With the zoom slider
[6]
the optical zoom of the camera can be changed absolutely. The left position correlates to
the maximum wide range, the right position to the maximum tele range. The digital zoom can not be influenced
here!
4.3.4 Standard Settings
On this tab you find controls for direct access to the settings of the internal camera menue, including the
configuration of camera audio.
In the audio settings you can choose between an automatic and a manual mode (see figure 4-8
[1]
).
Page 17 / 43
Distributed by: Reliant EMC LLC, 3311 Lewis Ave, Signal Hill CA 90755, 4089165750, www.reliantemc.com
