11
MK-5000G PrODUCT sPeCiFiCaTiON
The MK-5000G is not designed to cut plastic or ferrous (metals) material.
NOTe:
Your MK-5000G has been shipped from the factory thoroughly inspected. Only minimal assembly is
required. If not done, completely remove the plastic wrapping from the MK-5000G. Remove the ac-
cessories box from the Water Basin and remove the contents from the box.
MK-5000G
Block Saw
Movable Cutting
Table
Cutting Guide
Drain Plug
Blade Wrench
Owner's Manual
04.2015
MK-5000 GAS SERIES
OWNER'S MANUAL
PARTS LIST &
OPERATING INSTRUCTIONS
www.mkdiamond.com
Caution: Read all safety and operating instructions
before using this equipment. This parts list MUST
accompany the equipment at all times.
Revision 108
Manual Part# 160958
Engine Owner's
Manual
Warranty Card
UNPaCKiNG
CONTeNTs
In your container, you will find one (1) MK-5000G, one (1) movable cutting table, one (1) adjustable
cutting guide, one (1) drain plug, one (1) blade wrench, one (1) owner’s manual, one (1) Engine
owner’s manual and one (1) warranty card.
Masonry Types
The MK-5000G can cut a variety of masonry types including, cinder block, slump stone block, wall
brick, paver brick, concrete block and cylinders, roofing tile, marble, granite, decorative rock or almost
any other non-ferrous material.
spring assisted Cutting Head
The MK-5000G is designed with a spring-assisted cutting head to allow for easier step cutting. The
Cutting Head can be locked in the down position when cutting smaller pieces.
shaft Operated Water Pump
The MK-5000G has a flexible shaft, belt driven water pump supplying cooling water to the blade for
wet cutting operations.
