18
MK-5000G seTUP
Water Pump setup
Water Pump is factory installed and is setup for re-circulating wet cutting. If dry cutting, be sure to
disengage water pump. The Water Pump can be setup in three ways, External Water Source, Re-
circulation or Un-coupled for dry blade operation.
To extend the life of the Diamond Blade and Water Pump, MK Diamond recommends a
clean cooling water source when using a Wet Diamond Blade.
NOTe:
external Water source
This is the preferred method of cooling when using a “wet” diamond blade.
(A)
Remove the Drain Plug.
(B)
Remove Water Pump.
(C)
Place the Water Pump
Assembly into an external water
source container. Fill the external
water source container and place a
catch basin below the Drain Hole.
re-circulation
1. Water Pump could interfere with masonry being cut.
2. Water should be periodically replaced when using this method.
NOTe:
(A)
Install the Drain Plug. Fill the
water basin with clean water.
