ASSEMBLY
Remove the contents of the carton and
make sure that you have all the parts.
Fasten the base to the first Column
Surround. You will use the 1/4-20" Phillips Pan
Head screws. Making sure that the top speaker
grille is in place (CS-35, CS-29, CS-22 only),
turn the speaker over so that the two threaded
screw inserts on the bottom of the pedestal are
facing upward.
Use two 1/4 - 20 x 1" Phillips Pan Head
screws to attach the pedestal to the base. You
will first need to remove the screws that have
already been mounted in the speaker at the factory. Discard these screws and use the 1/4 - 20 x 1" Philips
screws, making sure that they are securely fastened so that the stand is stable.
Note that there is a recess at the bottom of the back baffle of the Column Surround cabinet just above the
point where the base is attached. When the base is attached, this forms a channel that can be used for
speaker wire routing.
Do not remove the 4 screws located at the rear of the Column Surround (see diagram).
Repeat these instructions to assemble the second stand.
MOUNTING THE COLUMN SURROUND TO THE BASEBOARD
Here are the parts you need:
2 each:
Column Surround Speakers
2 each:
Baseboard Mounting Brackets
8 each:
#6-32 x 1" Flat Head machine screw (PN 20356)
4 each:
#8 x 1-1/2" Flat Head wood screws (chrome)
TOOLS REQUIRED: Phillips screwdriver
ASSEMBLY
Remove the contents of the carton and make sure that you have all the parts.
Inorder to fasten the Wall Mount Bracket to
the Column Surround speaker. You will use the
#6 - 32 x 1" Flat Head machine screws.
Remove the existing 4 screws at rear of
cabinet.
The screws used to attach the bracket
mount into the four threaded inserts found at the
rear of the back baffle of the Column Surround.
For the CS-35, CS-29, and CS-22, this is direct-
ly behind the 6.5" woofer. You will first need to
remove the round head screws that are installed
at the factory before shipment. Set these round
head screws aside and mount the bracket using
the #6 - 32 x 1" Flat Head screws.
COLUMN SURROUND SPEAKER
8
OR
CS-22, CS-29, CS-35
CS-150
Side with countersunk holes
faces outward
Do not remove these 4 screws
