1.4
Set up the speaker
Launch the App you have just installed, follow the instructions on the App to setup the speaker.
Note: The device only supports 2.4GHz Wi-Fi, please make sure you phone is connected to 2.4G
instead of 5G.
Once the device is set up, it will be shown in the App’s device list. You can start using it.
2
Debug and Diagnostics
2.1
Updating software
You may have to update the speaker firmware, MCU firmware when there is a new release. Please
follow the following step to update the software.
1.
In the App, check and write down the device’s IP address by following below steps
->
->
2.
Download and UNZIP the firmware you want to update.
3.
On a PC that is connected to the same network, open a browser, type the IP address of the
speaker in the address bar and hit enter. You’ll see the web portal of the speaker, as shown
below.
