FGC100 User Manual
4
2
Introduction
The FGC100 calibration system is used to calibrate the FluxGage LED luminaire system. The
FGC100 includes:
12VDC adapter
Control unit
Lamp unit with protective cap
D-type cable
100-230VAC mains cable
Disk on key
Lamp Unit
Control
Unit
12VDC
Adapter
100-230VAC
Mains
D-type
Cable
Figure 1. FGC100 Block Diagram
The lamp unit includes:
LED mounted on a heat sink
Temperature sensor
Fan for temperature control.
D-type connector
White reflector
Protective cap for the reflector
Two thumb screws for attaching the lamp unit to the FluxGage lid
Figure 2.FGC100 Lamp Unit
Summary of Contents for Ophir FluxGage FGC100
Page 1: ...Ophir Optronics Solutions Ltd FGC100 Calibration Unit FGC100 User Manual FluxGage FluxGage...
Page 6: ...FGC100 User Manual 6 3 Mechanical Drawings...
Page 8: ...FGC100 User Manual 8 Figure 5 FGC100 connected to FuxGage...
Page 10: ...FGC100 User Manual 10 5 Performing Calibration of FluxGage Using FGC100...
