Document No 50398-001 Rev F 02 Aug 2020
12
of
20
12
of
20
2.1.3 Particulate Removal
The industrial laser environment has high levels of
particulates that must be removed from the camera FOV to
obtain accurate results. With BeamWatch, this is
accomplished by generating a laminar flow region at the
camera FOV using a clean, dry gas source. Air, Nitrogen, or
Argon is recommended. Connect the provided ¼” hose to
the gas source as shown in the diagram right.
2.1.4 BeamWatch Electrical
1.
Connect the provided power cord to the power
port on the BeamWatch unit.
2.
Connect the remaining end into a surge
protected 100-240 VAC outlet.
3.
Connect one end of the provided Ethernet
cable to the data source on the BeamWatch
unit.
4.
Connect the remaining end into an Ethernet
port on the PC, or connect to the Gigabit to
USB Adapter and connect the adapter to a USB
3.0 port.
Two plugs are provided to keep dust out of the BeamWatch system. Make sure
both
of these plugs
are removed before applying laser.