Document No 50398-001 Rev F 02 Aug 2020
14
of
20
14
of
20
2.
Insert the alignment tool into the BeamWatch with the
cutout side facing the camera as shown. Ensure the
alignment tool is flush with the top.
3.
Start the BeamWatch software and enable the Crosshair
located at the top of the 2D Beam Display window.
4.
Turn on the alignment beam and center it on the
alignment tool by adjusting either the beam or the
BeamWatch unit, with the beam perpendicular to the
BeamWatch as shown below.
The BeamWatch alignment tool is intended for
use with low power alignment beams. Severe
damage can occur if the high power beam is
directed when the alignment tool is in place.