INSTALLATION
Note - If this luminaire is being used in conjunction with an external PIR or sensor, please
confirm with the manufacturer of the sensors that they are compatible with LED lamps
• Provide power to the required point of installation (refer to BS7671 for correct cabling
methods)
• Suitable IP rated junction boxes should be used where required
• The luminaire should not be installed in areas where there is a high risk of flooding
• Round cable should be used for the mains supply. The use of flat cable will cause water
ingress to the fitting. The luminaire is supplied with an IP68 inline connector allowing the
termination of one 3-core flex up to 1.5mm
2
• If fixing into fresh concrete: screw the rods into the fixing plate leaving between 12–16mm
of thread above the surface and set it into the wet concrete (see Fig. 1)
Fig. 1
INSTALLATION & MAINTENANCE MANUAL
These instructions should be read carefully and retained after installation by the end user for future reference
and maintenance.
These instructions should be used to aid installation of the following products:
OL01B / OL01P
SAFETY
•
This product must be installed in accordance with the latest edition of the IEE Wiring Regulations
(BS7671) and current Building Regulations. If in any doubt, consult a qualified electrician
•
Please isolate mains prior to installation or maintenance
•
Check the total load on the circuit (including when this luminaire is fitted) does not exceed the rating of
the circuit cable, fuse or circuit breaker
•
Please note the IP (Ingress Protection) rating of this luminaire when deciding the location for
installation
•
This product is Class I and must be earthed
•
This product series is IP54 rated
INSTALLATION
Note - If this luminaire is being used in conjunction with an external PIR or sensor, please confirm with the
manufacturer of the sensors that they are compatible with LED lamps
•
Provide power to the required point of installation (refer to BS7671 for correct cabling methods)
•
Suitable IP rated junction boxes should be used where required
•
The luminaire should not be installed in areas where there is a high risk of flooding
•
Round cable should be used for the mains supply. The use of flat cable will cause water ingress to the
fitting. The luminaire is supplied with an IP68 inline connector allowing the termination of one 3-core
flex up to 1.5mm2
•
If fixing into fresh concrete
: screw the rods into the fixing plate leaving between 12
–
16mm of thread
above the surface and set it into the wet concrete (see Fig. 1)
Fig. 1
