~
230
V
/50
Hz
Yellow
/
Green
Red
Red
Triple terminal
Key words
Fig.
5
IMPORTANT SAFETY NOTES
- All work on the electrical connection and installation must be performed in accordance with applicable national and local regulations.
- All work on the electrical connection and installation must be carried out by suitably qualified personnel.
ELECTRICAL CONNECTION
- Before installing or connecting the system, make sure that the main power is turned off.
- Before connecting make sure that the voltage and frequency of the supply current match those listed on the label data.
Connect the power cord of the system to the mains in accordance with the wiring diagram.
MAINTENANCE
- Before maintenance or cleaning of the system ensure that the appliance is disconnected from the power supply.
- It is recommended the filter to be changed at least twice a year:
Changing the filter:
Turn off the system and wait 10 min. to release tension from the ionizer /in case the system is equipped with ionizer/!
remove the inner grid by pulling (Fig.3a);
loosen the screws and pull the inner part of the system to you;
• Use a screw driver to pull the unit out
/FILTER/ (
Fig
. F).
• Replace the filter and slide the unit back into the duct.
- We recommend periodical cleaning for smooth operation.
- For cleaning use a damp (not wet) cloth. Do not use abrasive cleaners or solvents.
- Do not use cleaning appliances with pressurized water or steam to clean the fan.
150
Ø100
min
27
0 / max
50
0
Hz/V
W
min
-1
IP
m /h
3
Fan
Ceramic Heater
50/2
3
0
5,5 - 9,2
500
1350 - 2650
X4
45 - 70
Dimensions / mm /
Technical data
ECO-FRESH
Minimal wall thickness 27 cm.
Maximal wall thickness 50 cm.
Dimensions
/
mm
/
CAUTION:
only AIR FLOW must be used with working fireplace.
From producer:
With unlit fireplace “Eco-Fresh 01 LUX" is recommended to work in AIR FLOW mode at first speed 24 hours a day.
*
The
elaboration
of a ventilation system, adjusted to other than the above wall thickness is possible by a clients request.
Rated
Voltage
Maximum
Flow
Power Consumption
Maximum rotational
speed
Protection
Degree
