8
The Q2M consists of :
The Q2M Rods and Clamps
The rods and clamps have been designed
so that they can be easily and quickly
connected to each other. You choose the
distances and angles by tightening or
loosening the clamps via an Allen wrench.
Adjustments can be done any time. For
adjustments at any time without an Allen
key, replace the bolt of the clamp by a
mini clamping lever (M5 or M6x25mm).
Combining clamps and rods
The 8mm and 6mm clamps and rods can
be combined when you mix an 8mm and a
6 mm clamp. Take the upper part of an
8mm clamp and the lower part of a 6mm
clamp. Assemble and fix both parts with
the bolt of the 6 mm clamp.
Q2M Bending Tool 6-8-10mm.
(TMHAT00005)
The rods can be bent with a bending tool.
Place a rod in the corresponding bending
slot (D6, 8 or 10 mm) and bend the rod till
the needed angle. The maximum bending
angle is around 90°.
Bending the rod more than 90° will more
or less damage the coating of the
anodized aluminium rods. The damage
consist of small visible cracks in the
surface of the curved part of the
aluminium bar.
Q2M Rod Lock, Assembly (M008-04)
The rod lock is a rotating swing system
that can be locked in any position and fits
in the Q2M Universal clamp. Just slide a
rod of diameter 6 in it and fix the rod in
the Quick Swing receiver with an Allen
key.
