Copyright © MOBA Mobile Automation Australia Pty Ltd
10
4.3.2 LEVELLING
When you turn the laser on, it will automatically level. The levelling process is indicated by a flashing laser
beam. After the laser has automatically levelled, the laser rotating head will start rotating at the speed of
600 RPM.
If the instrument is placed improperly, or the slope of instrument exceeds the range of
-
5° to +5°, the mode
indicator and the laser beam will flash at the same time.
Note: the instrument will shut down automatically if the unit exceeds the self
-
levelling range for more than
5 minutes.
4.3.3 ROTATING HEAD SPEED (OPTIONAL FOR LS.RH.HP VIA REMOTE CONTROL)
a. Continuous spinning
Press the Rotating Head Speed switch to control the speed of the rotating head. If the switch is pressed
repeatedly, the speed will correspondingly change to the following: 0, 60, 120, 300 & 600 RPM.
b. Stationary beam
Continue to press the Rotating Head Speed switch and set the speed to 0 RPM. The rotating head will
stop rotating. To move the laser rotating head clockwise, press the Beam Right switch. To move the laser
rotating head counter
-
clockwise, press the Beam Left switch.
