© MOBATIME
74 / 94
801299.00
9
SNMP
9.1
General
The SNMP version
V2c
or
V3
for
Get
,
Put
and
Notification
(Trap) is used.
A full SNMP agent is implemented on the DTS (MIB II, DTS4020).
Notice:
For detailed SNMP parameters please refer to MIB file.
See also end of this page.
For SNMP V2c, following standard
Communities
are used:
Read only:
romobatime
Read/Write:
rwmobatime
Trap:
trapmobatime
For SNMP V3, following standard
User I Passwords
are used:
dtsUser1
mobatime
dtsUser2
mobatime
dtsInfo
mobatime
(not changeable, read only)
DtsUser1 and dtsUser2 have full read/write access on all objects. With SNMP V3 rules,
access can be reduced. Changes of the rules can only be modified over the DTS menu
and not via SNMP.
SNMP V3 agent supports user validation (authentication MD5) and encoding
(encryption DES).
MIB II values like sysDescr, sysContact, sysName, or sysLocation can only be modified
over the DTS menu but not via SNMP.
The following MIB definitions are used:
SNMPv2-SMI, SNMPv2-MIB, SNMPv2-CONF, SNMPv2-TC, SNMPv2-TM,
SNMP-FRAMEWORK-MIB, SNMP-MPD-MIB, SNMP-NOTIFICATION-MIB,
SNMP-TARGET-MIB, SNMP-USER-BASED-SM-MIB, SNMP-VIEW-BASED-ACM-MIB,
RFC1213-MIB, IF-MIB, IP-MIB, IP-FORWARD-MIB, TCP-MIB, UDP-MIB,
HOST-RESOURCES-MIB, HOST-RESOURCES-TYPES, DISMAN-EVENT-MIB,
NOTIFICATION-LOG-MIB, UCD-SNMP-MIB, NET-SNMP-MIB, NET-SNMP-TC
SNMP V2c, V3:
DTS-COMMON
(File: DTS-COMMON-MIB.TXT)
General DTS definition, always required
DTS4020
(DTS4020-MIB.TXT)
Device-specific DTS definitions
MIB-Files copy from DTS device:
The MIB files can be copied from the DTS 4020 with FTP (For FTP use, see chapter
“7.6 FTP connection“):
DTS-MIB:
/etc/snmp/mibs/
Standard MIBS:
/usr/share/snmp/mibs/
