© MOBATIME
14 / 108
801104.05
5
Installation
5.1
Connections
The connections are specified in Appendix “A Connection diagrams“.
Only connect the designated devices to the various inputs and outputs.
5.2
Boot procedure of the DTS 4132.timeserver
The normal booting time of the DTS 4132 is approx. 60 sec. with pre-set IP or with
DHCP. The booting procedure of the operating system is displayed on the serial
console. After that, the text "starting" appears on the display (during the booting
procedure the display is dark and empty). Without connection to a DHCP server, the
first start up can take up to 75 seconds. After that, the DHCP option must be set to "off"
in the network configuration.
The display “starting“ remains until the time of output to the lines.
The duration, depending on the configuration, is 5-30 sec.
5.3
Initial configuration
Per default, the LAN 1 interface is configured with DHCP on. After booting in a network
with DHCP server, the received IP address can be displayed.
The LAN 2 interface is configured with the following static settings per default:
IP 192.168.1.5, Subnet 255.255.255.0, Gateway 192.168.1.1
If these possibilities do not work out for the initial configuration, the network
configuration can be modified using a USB stick. For this purpose, a text file named
DTS4132NW.conf
is created and filled with the corresponding parameters (not all
parameters are required):
IP1:192.168.1.3
SUB1:255.255.255.0
GW1:192.168.1.1
IP2:10.0.0.7
SUB2:255.255.240.0
GW2:10.0.0.1
The insertion of the USB stick is displayed. For taking over the network settings, press
the button until the normal time display reappears.
5.4
Firmware
It is recommended to install the current firmware on your device prior to the definite
commissioning. The current firmware can be found under
www.mobatime.com
Customer Data
Product Resources
Time Server
.
5.5
Basic settings (factory settings)
The basic settings can be found in the table in Appendix “G Parameters”.