background image

Recharging the Rechargeable Batteries

 • Charging when Monitor is “ON” – The LED indicator will show red while charg

   ing and will turn fully green when fully charged.

• Charging when Monitor is “OFF” – LED indicator will show red while charging, 

   once fully charged, it will briefly turn green and then turn off. Turn on Monitor to

   verify charging status.

Additional Battery Notes:
• When operating the monitor on battery, the LED indicator will turn red 10 min-

   utes before the unit turns off from low charge.

• When first charging the batteries, charge for 11 hours.

• To fully recharge the batteries, charge for 8 hours.

• When monitoring over long periods and, in particular, overnight, it is recomend-

   ed to use the AC/DC Adapter for the Monitor.

• Use VOX or Audio Only mode to extend battery life.

• Under optimal conditions, the battery charge will last for up to 

   6 hours. Continuous use of video on will greatly shorten battery life.

• All rechargeable batteries last for lessening periods of time after hun-

   dreds of recharges and eventually need to be replaced. 

• If the monitor is to be used in several locations, Mobi

®

 recommends 

   the purchase of additional AC/DC adapters.

MONITOR / CAMERA OPERATION

Monitor Power ON/OFF

Switch the Power ON/OFF 

Selector 

(Fig. 4, no. 2)

 to the 

ON position. The power 

indicator light 

(Fig. 4, no. 4)

 

will turn on indicating the 

Monitor is ON.

Volume Adjustment

                                                      

Press the Volume Up ( + ) 

Button 

(Fig. 4; no. 5)

 or 

Volume Down ( - ) Button 

(Fig. 4; no. 7)

 to adjust the 

volume to the desired level. 

This image 

(Fig. 9)

 will 

appear on screen to indicate 

the sound level.

6

7

POWERING UP

The Mobi

®

 Secure Start

 Camera is powered by an AC/DC Adapter while the 

Monitor can be powered by either rechargeable batteries or an AC/DC Adapter 

(both provided).

Using the AC/DC Adapters:

• Plug the connector of the AC/DC Adapters into the DC Jacks on the Monitor

  and Camera units 

(Fig. 5; no. 9 and Fig. 8; no. 18). 

Both AC/DC Adapters are

  the same and are interchangeable between the Monitor and the Camera.
• Plug the adapter power cords into a standard AC outlet.
• To check the Monitor, switch the Power ON/OFF Selector to the ON position

  

(Fig. 4; no. 2).

• To check the Camera, switch the ON/OFF Selector to the ON position 

(Fig. 7;

  no. 17).

• The power indicator lights will illuminate indicating that the units are ON

  

(Fig. 4; no. 4 and Fig. 7; no. 14)

.

Using Batteries:

• Remove the battery door 

(Fig. 6, no. 12)

 on your Monitor using a screwdriver

  and insert the Mobi

®

 rechargeable batteries.

• Return the battery cover to the original position and secure the screw with a

  screwdriver and allow the batteries to charge with the AC/DC Adapter con-

  nected.
• The battery indicator light will turn red when batteries are low.

  Note: One battery charge lasts up to 6 hours. When monitoring over long

  periods and, in particular, overnight, it is recommended to use the AC/DC Adap-

  tor for the Monitor

.

 

  Warnings:

             1. Replace rechargeable batteries with Mobi

®

 rechargeables ONLY.

 

2. When using non-rechargeables do not mix old and new batteries.

 

 3. Do not mix alkaline, standard or rechargeable batteries.

 

  4. Remove the batteries during long periods of non-use.

 

   5. Please dispose of old, defective batteries in an environmentally

 

         friendly manner, in accordance with the relevant legislation.

 

      6. Use only the AC/DC Adapters supplied with the system.

 

        Note: Camera only functions while its AC/DC Adapter is connected.

Summary of Contents for Secure Start










Reviews: