Draft
20
DOC-0132 Crewsafe User Manual v.1.2
Mobilarm Ltd. © 2009
6.2
Attaching a Tag
Crewsafe Tags are small enough to be worn at all
times in all marine environments. Tags are designed
to be attached to clothing, lifejackets or harnesses
that include:
·
Belts.
·
Harnesses or webbing.
·
Life jacket straps.
·
Pockets/lanyards*/safety chains to avoid the
loss of a Tag over the side of a vessel.
*Lanyards are
not
recommended as the best
method of attachment.
Mobilarm recommends that Tags
are worn at waist level, both for
comfort and to ensure a man
overboard alarm is activated in an
emergency.
Attaching a Tag
There are two different clips that can be used to attach a Tag. To attach a Tag with a
mini-clip to a crew member it is necessary to thread a harness or webbing through
the gap between the Tag and clip. The large Tag clip is able to slide directly onto a
belt or strap and is much simpler to attach.
Attaching a Clip
To attach either of the two different Tag clips to a Tag, slide it onto the Tag until it
locks firmly into place. To remove it from the Tag, push the TAG LOCKING CLIP
away from body of the Tag and then slide it upwards to remove it. Note: If you are
using the large Tag clip then it needs to be removed before placing the Tag into a
Power Dock for charging.
