Draft
39
System Maintenance
Mobilarm Ltd. © 2009
To reset a Display Console to its factory defaults please see the section titled
Reset: Reassign Tags & Routers
Note:
When a Display Console is set back to its factory default settings, it does not
totally reset Tags. Tags retain their previous registration information and simply need to
be reconnected to the network to be reassigned to the Display Console.
8.2
Adding a Tag to the System
New Tags may be added to the Crewsafe network as replacements for lost tags or to
accommodate an increase in crew members.
New Tags may be supplied:
a. Pre-configured with the correct Network ID, or
b. Pre-configured with an incorrect Network ID.
If a Tag is pre-configured with the correct Network ID then it should automatically connect
to the network once it is turned on.
When a Tag that is pre-configured with an incorrect Network ID is turned on and tries to
connect to the existing network, its TAG STATUS LED will flash red.
If a Tag is pre-configured with an incorrect Network ID it needs to be reconfigured with
the correct Network ID for the existing network
Adding a Tag with the Correct Network ID
1. Press the Display Console POWER button to turn the Crewsafe system on.
2. Press the Tag BUTTON.
When a configured Tag is turned on:
·
The STROBE light flashes twice and the Tag STATUS LED flashes red briefly.
·
The TAG STATUS LED flashes green once it has been registered to the
network successfully.
·
The next available TAG STATUS LED on the Display Console is allocated to
the new Tag and illuminates solid green.
Reconfigure a Tag to the Correct Network ID
Reconfiguration of a Tag to the correct Network ID can be performed using the
Display Console, or a configured Tag, i.e. one that has connected to the network
previously.
Reconfiguration using a Display Console
This is the simplest way to reconfigure a Tag to the existing network.
