Draft
44
DOC-0132 Crewsafe User Manual v.1.2
Mobilarm Ltd. © 2009
8.6
Factory Reset: Reassign Tags & Routers
Tags are initially assigned to a Display Console panel in the order in which they are
registered to the network. It is possible to change the order of Tags on a Display Console,
or remove Tags from the system, by performing a factory reset on the Display Console.
The system is limited to 12 Tags if a Display Console is used without the Crewsafe
Management System because there is a maximum of 12 TAG STATUS LEDs on the
Console.
Technical Tip:
A factory reset can only be performed if the system is
turned off and the Display Console has ship's power connected to it. Once
you have performed a factory reset you must turn off power to all Internal
and External Routers, or the routers will not rejoin the network. The only
way to do this is to briefly turn off ship's power to all Internal and External
Routers.
Initiating a Factory Reset
To initiate a factory reset of a Crewsafe system, simultaneously press and hold the
ALARM, DIM and POWER buttons for 5 seconds.
During initialization:
1. The Display Console NETWORK STATUS LED flashes red and all lights on
the front panel flash orange 8 times.
2. All lights go out for a couple of seconds.
3. All lights on the front panel illuminate orange and the NETWORK STATUS
LED illuminates purple for a couple of seconds.
4. The NETWORK STATUS LED flashes blue as it attempts to reconnect the
network of installed routers.
After performing the factory reset:
·
All routers in range are automatically rejoined to the network.
·
All Tags are reassigned to the Display Console when they are switched on (in
the order that information is received from them).
