PG 12
PG 13
©Copyright 2020 Mobilate LLC All rights reserved
P/N: 400.160 Rev 3
©Copyright 2020 Mobilate LLC All rights reserved
P/N: 400.160 Rev 3
5.1.3
Once the Lower Leg (15) is slid inside the Rear Leg Upper (11) slide the Leg
Cuff (13) up onto the end of the Rear Leg Upper until it is all the way home
and well seated. Hold the Leg Cuff (13) in position on the Rear Leg Upper (11)
and tighten the locking screw to secure the Leg Cuff (13) in position.
5.1.4
Adjust height of rear Lower Legs by depressing the Spring Pin (14b) and
sliding the leg up or down. You should adjust so that Spring Pins are in the
same hole number on all 4 legs.
Don’t worry about adjusting the overall product height yet, that will be
addressed later in the manual.
5.2.1
To start check that the Fold Lock (5)
is set to fold position (horizontal). If
it is, proceed to step 5.2.3
If not proceed to 5.2.2
5.2.2
If the Fold Lock (5) is in the vertical position, press the Safety Button (4),
squeeze the Lever (3) and while holding the Lever (3) turn the Fold Lock (5)
90° to the horizontal position. Repeat for the other handle. The Roami PMA
is now free to unfold.
At the bottom of a stairway (or sloping ground),
lift the front feet or wheels up onto the first step
Press both the Safety Locks (4) inwards until they click.
The Safety Locks (4) should stay depressed until the
Clutch Levers (3) are depressed and released.
Using your Roami PMA as a stair climber
Inclines
Grasping the Handles (2), squeeze both Clutch Levers (3) simultaneously.
The product will adjust to the height of the stairs under it’s own weight
Continue up the stairs or slope with
the Roami PMA locked in it’s adjusted position.
Squeeze both Clutch Levers (3) simultaneously an d the front legs of the device will automatically drop down to the surface.
Once at the top, place the rear feet on the top step,
press the Safety Locks (4),
Once the rear feet hit the lower ground,
release the Clutch Levers (3).
The Safety Locks (4) will spring out and re-engage and
the Roami PMA will be automatically locked into the
angle of the stairs or slope.
x2
At the bottom of a stairway (or sloping ground),
lift the front feet or wheels up onto the first step
Press both the Safety Locks (4) inwards until they click.
The Safety Locks (4) should stay depressed until the
Clutch Levers (3) are depressed and released.
Using your Roami PMA as a stair climber
Inclines
Grasping the Handles (2), squeeze both Clutch Levers (3) simultaneously.
The product will adjust to the height of the stairs under it’s own weight
Continue up the stairs or slope with
the Roami PMA locked in it’s adjusted position.
Squeeze both Clutch Levers (3) simultaneously an d the front legs of the device will automatically drop down to the surface.
Once at the top, place the rear feet on the top step,
press the Safety Locks (4),
Once the rear feet hit the lower ground,
release the Clutch Levers (3).
The Safety Locks (4) will spring out and re-engage and
the Roami PMA will be automatically locked into the
angle of the stairs or slope.
x2
5.2 UNFOLDING THE ROAMI PMA FOR USE
