STEP BY STEP USER GUIDE
NOTE: The Headset is intended to be worn with the microphone
and cable on the wearer’s left hand side.
STEP 1
Fitting the Mic. Boom
Fit th
d on
the
Rot
Cu
e Microphone Boom assembly to the mounting socket locate
Left Side
Ear Cup (cable side).
ate the collar clockwise whilst screwing onto the socket on the Ear
p. Firmly
finger-tighten
only.
Partly bend the boom to where you estimate your mouth will be,
ensuring the
Yellow Dot
is facing
towards the mouth
.
Figure 1.0
STEP 2
Fitting the Headset onto the Hardhat (Typical)
Insert the Hardhat Adaptor Plate for each
of The two Ear Cups into the slot provided
of each side of the Hardhat. This can be
easily done by using your fore finger and
index finger as an anchor and firmly
pushing in with your thumb until the
Adaptor locks into place. Check that they
are correctly locked in by trying to pull
them out again. The adaptors should
remain firmly in place. Ensure that Ear
Cup with Mic. is fitted to the left side of
hardhat.
Figure 2.0
4
