7
7
Release the lock from the media stopper (Pull the sides and slide it forward).
Release
the media
stopper
Media stopper
Supplement
'LUWIURPWKHÁRRUPD\VWLFNWRWKHPHGLDZKHQ
giving it slack, so please be careful.
8
When the set lever is up (and the media is held down by the push rollers)
and the media stopper is unlocked, pull out the roll media and give it
slack.
Give it slack
Create the same amount of slack in the media as will be used for the
back of the machine.
When using the roll media tray
Create the same amount of slack in the media
as will be used for the back of the machine.
Step 1: Raise the set lever
DQGÀ[WKHPHGLD
Step 2: Create slack.
Give it slack
Loading Sheet Media
Supplement
See "Aligning the Push Rollers" about the
position of the push rollers.
1
Lower the media set lever to raise the push rollers.
Media sensor
Push roller
Media set lever
Once the USB and power cables have been plugged into the cutting plotter, plug
both the cutting machine power and tablet power into your wall outlet. If necessary
use the included plug adapters.
Once plugged in the green light
on the top right corner of the
tablet should light.
If the green light does not come on
press the power button located
on the back side
of the tablet mount
2
.2
Plug the USB cable into the USB port
located on the right side of the cutting machine
Plug the USB cable into the USB port
located on the right side of the cutting machine
to cutting machine
Plug the power cable into the power input
located on the left side of the cutting machine
to cutting machine
