Mobilex A/S
Grønlandsvej 5
DK-8660 Skanderborg
www.mobilex.dk
8" front wheels
The wheelchair is equipped with PU wheels 200x50 mm as standard. We recommend to
stay with this type of tyres, but it is also possible to use pneumatic tyres. It is possible to
mount different sizes of front wheels. This is made necessary by adjusting the rear axles
(see also the table below). If the vertical position of the rear wheels is changed, it is
necessary to adjust the position of the front wheels accordingly. The vertical axis of rotation
of the fork should always be set at a 90° angle to the ground (+/- 2°). It is possible to adjust
the desired angle by turning the eccentric screw (1).
If the adjustment range needs to be larger, it may be necessary to move the front wheel
axle to another hole (A, B, C, D) by loosening the screw (2) and moving the wheel up or
down to the desired height and tightening it again. In some cases it may be necessary to
replace the standard front wheels (8") with a wheel of a different size (6" or 7"). The table
below shows the possible wheel positions. It provides a clear overview of seat heights, rear
wheel positioning holes, correct front wheel sizes and positions.
Correct positions and front wheel sizes depending on desired seat height:
Desired seat
height
Position of the axle mounting
plate (hole numbers)
Front wheel position
(hole designation on the fork)
Correct wheel size
at the front
45,0 cm
1+2
B
6”
46,3 cm
2+3
B
7”
47,7 cm
3+4
C
7”
50,0 cm
4+5
C
8”
51,3 cm
5+6
D
8”
Wheelchair transportation
Car transport
Place the wheelchair in the car boot. If, for some reason, it is not possible, put the
folded wheelchair between the front and the rear seats inside the car ensuring that
the wheelchair is in a sure and stable position. If it is not possible the wheelchair
should be fasten with the safety belt.
WARNING!
The wheelchair is not the car seat. During traveling by vehicles seating
on the wheelchair is not allowed. The chair should be folded and safely
immobilized.
Accessories
As an option, the wheelchairs can be equipped with the following accessories (not part of
the standard equipment)
✔
Anti-tip
✔
Transfer wheels
✔
Safety belt
✔
Drum brakes
✔
Angle and height adjustable footrests
✔
Tensionable back (Velcro back)
4. Technical data
Dolphin:
Dolphin has been successfully crash tested to ISO 7176/19 in its standard version. The Heavy Duty version was not
tested. Standard version can be used as a vehicle seat for users weighing 75 kg and 136 kg.
The wheelchair is designed to be forward-facing when used as a seat in a motor vehicle. The occupant should
transfer to the vehicle seat and use the vehicle-installed restraint system whenever it is possible! In order to fasten
the wheelchair to the floor of the vehicle, only use restraint systems which meet the standard ISO 10542.
Rev. 04-22
24/48
UM-Dolphin-Barracuda-MULTI-29042022
Dolphin Rollstuhl mit
Trommelbremsen
