Pag. 44 / 64
2BB 360N
Manuale di Installazione e Service
REV.
01
23/03/2016
Fitting and Service Handbook
Mobility Networks
12 Estuary View Business Park, Whitstable, Kent, CT5 3SE, UK
Tel: +44 (0)1227 505022 Fax: +44 (0)1227 505023 www.mobilitynetworksgroup.com
Mobility Networks is a trading name of Mobility Networks (Holdings) Ltd. Registered in England & Wales number 08295602
9.8. Verifica delle regolazioni / Regulation check
Verifica /
Verification
Intervento /
Intervention
Tempo richiesto
Time required
10’
20’
Personale necessario
Personnel required
1
1
Strumenti
Equipment
Nessuno
None
Attrezzi da banco
Tool kit
Materiale
Materials
Nessuno
None
Nessuno
None
Descrizione
Description
Eseguire n°2 cicli completi di apertura, discesa,
salita,
chiusura
e
verificare
il
corretto
posizionamento della pedana al piano di carico da
e la corretta chiusura del sollevatore.
Carry out n° 2 complete cycles of deploying,
lowering, lifting and stowing and check the correct
positioning of the loading platform at vehicle deck
level, the correct closure of the lift.
Vedi NOTE.
See NOTE.
PROGRAMMAZIONE ANGOLO DI SALITA
Disabilitare il sistema (chiave staccabatteria)
premere i pulsanti UP+DOWN,
riabilitare il sistema mantenendo premuti i pulsanti
UP+DOWN,
rilasciare i pulsanti e muovere il sollevatore alla
posizione desiderata;
dopo 5 secondi dove nessun pulsante è premuto, il
LOAD ANGLE è programmato.
PROGRAMMAZIONE ANGOLO DI CHIUSURA
Turn-off the system;
Push buttons STOW + DEPLOY;
Turn-on the system while pushing buttons STOW +
DEPLOY;
Release buttons STOW + DEPLOY and move
wheelchair lift to desired STOW ANGLE;
after 5 second swith no buttons pushed, the desired
STOW ANGLE is programmed.
PROGRAMMING LOAD ANGLE
Turn-off the system;
Push buttons UP + DOWN;
Turn-on the system while pushing buttons UP +
DOWN;
Release buttons UP + DOWN and move wheelchair lift
to desired LOADANGLE;
after 5 second swith no buttons pushed, the desired
LOADANGLE is programmed.
PROGRAMMING STOW ANGLE
Turn-off the system;
Push buttons STOW+ DEPLOY;
Turn-on the system while pushing buttons STOW+
DEPLOYWN;
Release buttons STOW+ DEPLOYand move
wheelchair lift to desired STOW ANGLE;
after 5 second swith no buttons pushed, the desired
STOW ANGLE is programmed.
