28
/40
Mx2wire User Manual:
InSTALLATIOn
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • sales@mobotix.com
2.6 Installation using Surface-Mounted Socket
1. Prepare
the surface-mounted socket:
Use the supplied
drilling template for the surface-mounted socket (fold-
out at the end of this manual) to mark the precise position
of the drill holes and the cable guide. Make sure that
the alignment and position of the socket in relation to
the two-wire cable are correct (TOP / OPEN arrow).
2.
Feed in the two-wire cable and screw on the surface-
mounted socket:
Feed the two-wire cable through the
opening provided that is sealed with a rubber plug.
Use the 8-wire plug for multi-wire cables. You only require
two of these wires for Mx2wire. The other two plugs
with only one opening are ideally suited to insulated,
two-wire cables of varying thickness.
Now use the four Torx screws (item 1.6) to securely
fasten the surface-mounted socket to the screw anchors
or directly to the (wooden) surface. Please ensure that
you only use the existing four drill holes of the surface-
mounted socket.
3.
remove the Mx2wire front panel and frame:
In order
to protect the Mx2wire circuit board, the board is
attached to the front panel and frame in the original
packaging. In order to continue with the installation,
however, you must fi rst separate the housing and
circuit board (item 1.1) from the panel and frame. Loosen
the screw in the front panel (item 1.2) and lift the panel
forwards.
Now remove the attached frame from the circuit board.
Please note that you will need the stainless steel screw
in the front panel again later.
Supplied cable plugs
For cables of 3 - 5 mm
For cables of 5 - 7 mm
For cables with a maxi-
mum of eight wires
The screw does not need
to be removed completely
from the front panel
Alle Bohrungsdurchmesser 5 mm
Security-Vision-Systems
AG
1:1
MOBOTIX
g
Mx2wire-Bohrschablonen
Mx2wire-Bohrschablone
14.07.2009
Tp
SolidWorks
CAD-A4
Werkstoff
Gewicht
Zul. Abweichung für Maße ohne Toleranzangaben:
mittel DIN 7168
Maßstab
Bearb.
Geprüft
gemacht werden.
Ersatz für
Änderung
Name
Bez.
Norm
Datum
Blatt 1 von 1
Name
Datum
Für diese Unterlage behalten wir uns
alle Rechte vor. Sie darf nur für den
von uns bestimmten Zweck benutzt
und ohne unsere Zustimmung weder
vervielfältigt noch Dritten zugänglich
www.mobotix.com
X
40
60
60
60
