29
/40
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • sales@mobotix.com
4.
Screw the two-wire cable to terminals 1 and 2:
The cable does not necessarily need to be attached
to the terminal with the same number on both
Mx2wire units. The device continues to function
if connectors 1 and 2 are swapped.
The two connectors 3 and 4 are (currently still)
unassigned and cAnnOT be used.
5.
Insert the housing and circuit board into the
surface-mounted socket:
The two cable clamps on
the rear of the housing are located at the top. Attach
the housing and circuit board to the surface-mounted
socket by fastening the four stainless steel screws (item
1.4) in the four existing drill holes.
6.
Attach the frame:
Place the selected frame (item 1.3,
concave, convex or fl at) onto the circuit board and press
down gently until it automatically snaps into place.
MOBOTIX is printed on the bottom of the frame.
7.
Insert the panel:
Hook the front panel onto the frame,
as shown in the fi gure, and then press it down.
8.
Screw the panel on tightly:
Secure the front panel
using the panel's stainless steel screw. Continue with
Section 3 (Operation).
The device continues to
function if connectors
1 and 2 are swapped.
First attach the panel below,
then hook it on above
