www.mocdoor.com
garage door opener/roller door opener/door components
CHANGE THE ACCESS PIN CODE
Channel: 1
1. Make sure the NEW access pin code has already been recorded.
2. Press and HOLD ON
the “0” key and press the key.
3. Release key,
release “0” key.
4. ENTER current cod
e “11” and press the key.
5. ENTER new access pin code (any combination up to 8 digits) and press key.
6. ENTER new access pin code AGAIN and press the
key.
Channel:2
1. Make sure the NEW access pin code has already been recorded.
2. Press and HOLD ON
the “0” key and press the key.
3. Release key,
release “0” key.
4
. ENTER current code “22” and press the key.
5. ENTER new access pin code (any combination up to 8 digits) and press
key.
6. ENTER new access pin code AGAIN and press the
key.
IMPORTANT NOTE:
1. If both channels are programmed with the
same
PIN code, then after typing PIN code,
pressing of or will both enable the output signal.
2. If programmed
NO
code into the keypad, then the security function is out of action and
by pressing of or keys will both enable the output signal.
AUDIO ALARM
1 time SHORT beep
– Keypad normal tone
1 time LONG beep
– Auto power OFF
3 times LONG beeps
– Confirmation of successful access pin code modification
5 times SHORT beeps
– ERROR during access pin code modification
