Page 27
MOCET IP3022 SOHO IP Deskphone User Guide
1. You make a call to the called party who is not available, does not answer the phone or
is busy.
2. At the time, your phone will get “Busy here” on display.
3. Then after the called party’s phone returns to idle screen, your phone will get “Active
Call Completion to xxx (called party phone number)?” on display.
4. You can select “OK” or “Dial” to dial the called party’s phone number out, or select
“Back” or “Cancel” to ignore this message.
The feature is disabled by default. If you want to have call completion feature, just enable
it.
Note: If the called party’s phone has Call Waiting enabled or Voicemail enabled, the Call
Completion feature will be ignored.
2.3.6.
Auto Redial
The phone supports Auto Redial that redials a busy number in a fixed number of times
before giving up. It is useful when you are trying to call someone who is on a call.
To configure Auto Redial:
1. Enter Auto Redial page.
2. Select Redial Enable and press
OK
key to enter the page to enable/ disable auto
redial function.
3. When auto redial function is enabled, you may change the Redial Times and Redial
Interval to meet your need.
Redial times: It is used to set the redial times. The default is 5 times.
Redial interval: It is used to set the period to redial again when the call is denied
access or expire. It is measured by seconds. The default is 30 seconds.
2.3.7.
Hot Line
The phone supports Hot Line. When phone is off hook, it auto dials out the hot line number
after the configured delay time duration is up.
To configure Hot Line:
1. Enter Hot Line page.
2. Configure the Hot Line Delay and Hot Line Number to meet your need.
Hot Line Delay: It is used to set the delay time. The default is 2(s).
Hot Line Number: It is the number to be auto dialed out.
