16
17
UI Combinations
Quick Recalls
COBALT8 has 8 Quick Recall slots for quickly loading presets. Quick Recalls are controlled
using the following button combos:
•
Hold ‘Patch’ + hold one of the eight buttons on bottom left of the panel to assign the
currently loaded patch to a QR slot
•
Hold ‘Patch’ + press one of the eight buttons on bottom left of the panel to load the
patch in the QR slot
LFO
•
Turn the ‘Rate’ encoders into the negative range to access synced rates
•
To access LFO3 parameters enter ‘Shift’ mode and press the LFO2/LFO3 button
Filter
•
Hold the ‘Patch’ button and turn the ‘Cutoff’ encoder to control the Filter Type parameter
Envelopes
•
Hold either the FILT-EG or AMP-EG button for one second and then turn the ADSR
encoders to adjust all envelopes simultaneously
•
Press the ‘MEG’ button when MEG is already selected to latch MEG assign
Sequencer
•
Hold the ‘Mute’ button to clear the sequencer notes
•
Hold the Anim1 / Anim2 / Anim3 / Anim4 buttons to clear an animation lane
•
When the screen is displaying the ‘Linked Sequence’ parameter, hold the ‘Edit’ switch to
set the value to be the currently loaded sequence.
•
Hold the ‘Patch’ button and press the ‘Record’ button to enter the Step Sequencer ‘Edit’
Mode, if the currently loaded sequence is in ‘Step’ mode
UI Combinations
Arp
•
Hold the ‘Arp’ button and press keys on the internal or an external keyboard to add
pattern notes or press the ‘Rest’ button to add a rest to the pattern
•
Hold the ‘Patch’ button and turn the ‘Division’ encoder to control Arp Gate
Keyboard/Voice
•
Press ‘Unison’ repeatedly to cycle through the different unison modes; press ‘Stack’
repeatedly to cycle through the different stack modes
•
Press ‘Chord’ whilst holding a chord on the internal or an external keyboard to set the
chord mode chord.
•
Hold ‘Transpose’ and press a key on the internal keyboard to transpose all notes, where
the central C key is the root note. Press ’Transpose’ with no keyboard interaction to reset
the transpose value back to 0.
•
Hold the ‘Sustain’ button for one second when turning on Sustain to enable Sustain
‘Latch Mode’
•
Hold the ‘Patch’ button and turn the ‘Drift’ encoder to control the Chord Invert
parameter.
Modulation
•
To assign a Mod Slot either hold (momentary) or latch the desired Mod source button -
then set a depth by turning desired modulation destination parameter encoder
•
When latched in a Mod Source assign mode pressing the flashing Mod Source button
again will exit assign mode
•
Mod source ‘Depth’ encoder - set global depth for that mod source
•
Press ModSlot repeatedly to cycle through and view all mod slot settings on the screen
•
When the screen is displaying a mod slot ‘Depth’ parameter (most easily accessed via
assigning modulation using the panel or via the ModSlot button), hold the ‘Edit’ switch to
clear the mod slot assignment.
•
To assign a mod source to the global frequency destination, use either of the fine tune
controls. ‘Tune1’ will assign to Osc1 tune, ‘Tune2’ will assign to Osc2 tune.
Summary of Contents for COBALT8
Page 13: ...24 25 03 Synthesis engine...
