30
31
FX
CRAFTsynth 2.0 features two built in effects, a waveshaping distortion and a delay.
•
Distortion:
When holding the SHIFT key this encoder allows us to control the Distortion
amount. The distortion is a waveshaping overdrive and as such is incapable of bit-
crushing effects.
•
Delay:
When holding the SHIFT key this encoder allows us to control the Delay amount
within this patch.This parameter affects the Dry/Wet mix of the of the delay audio effect
at the end of the audio signal chain. When set to minimum, only the dry signal will be
heard. When set to maximum, only the delayed signal will be heard.
•
Time:
When holding the SHIFT key this encoder allows us to control delay Time of the
Delay effect, from 0.022 to 750ms. In negative amounts it will sync to subdivisions of the
tempo (1/16, 1/12, 1/8, 1/8D, 1/4, 1/2, 3/4, 4/4, 6/4)
•
Feedback:
When holding the SHIFT key this encoder allows us to control Delay Feedback.
This sets the amount of delayed audio signal fed back into the delay input. When at the
fully left position, only the first delayed signal will be heard. All the way to the right,
almost the entire level of the delayed signal is fed back into the delay. This can be used
to create a wide array of effects from an echo or reverb-type effect, to noise and metallic
sounds.
