36
37
MIDI
Arp / Seq Out
Enables / disables MIDI note output from the arpeggiator and sequencer. If this setting is
enabled and the arpeggiator is active then the internal keyboard notes will not be transmitted
to MIDI-out. Please note that MIDI-in notes that are being arpeggiated will also be transmitted
to MIDI-out if this setting is enabled, which may cause MIDI loop / echo issues in complex
MIDI setups.
This can be set from the panel by holding the ARP button whilst powering on the device and
using touch pads 1-8 to turn off this setting or touch pads 9-16 to turn on this setting.
Polychaining
Polychaing is available for up to 4 SKULPTsynth SE or SKULPTsynthesiser units together for up
to 16 voices of polyphony:
•
Connect desired master din out to first drone din in.
•
Connect additional drones (Maximum 3 drones per master, 4 in total) in the same way,
din out -> din in.
•
Power on drone SKULPTsynth SE or SKULPTsynthesiser.
•
Power on master SKULPTsynth SE or SKULPTsynthesiser holding down the VOICE button
and select the number of drones on the Touch Pads.
•
Release VOICE button. An LED animation should run accross all SKULPT units and will
disable the drone’s front panel. The VOICE LEDs will be lit and the drone number flashing
on the touch pads.
MIDI CC Implemention Chart
Function
CC
Values
Seq Load
0
0 - 63
Modulation Wheel
1
“
Glide
5
0 - 2.5 seconds, exponential
Headphone Volume
7
Silence - full volume
Voice Mode
9
0 - 42 = Mono; 43 - 85 = Duo; 86 - 127 = Poly;
Expression Pedal
11
“
Distortion
12
Dry - Wet
Delay
13
Dry - Wet
Delay Time
14
No Sync: 0 - 250 milliseconds / Sync: 8 steps, Longest delay time
possible divided down
Delay Feedback
15
0% - 90%
Osc1 Wave
16
0 - 21 Sine / 22-42 Tri / 43-63 Saw / 64-127 PWM duty 50% - 5%
Osc2 Wave
17
0 - 21 Sine / 22-42 Tri / 43-63 Saw / 64-85 Square / 86-127 White
Noise
Osc Mix
18
Osc1 - Osc2
FM Amount
19
0 - Full
Spread
20
0 - 63 Unison / 64 - 70 Major / 71 - 77 Minor / 78 - 84 Major 6th /
85 - 91 Sus 4th / 92 - 98 5ths / 99 - 105 5th + Oct / 106 - 112 Oct
+ 1 + 2/ 113 - 119 Oct + 1 -1 / 119 - 127 Oct -1 -2
Chord Mode
21
0 - 63 = OFF / 64 - 127 = ON
FEG Attack
22
0 - 4 Seconds
FEG Decay
23
0 - 4 Seconds
FEG Sustain
24
0 - 1
FEG Release
25
0 - 4 Seconds
AEG Attack
26
0 - 4 Seconds
AEG Decay
27
0 - 4 Seconds
AEG Sustain
28
0 - 1
AEG Release
29
0 - 4 Seconds
Osc2 Course
Detune
30
+/- 4 Octaves
