www.modecom.eu
4
laser mouse
Steps of removing the receiver and installing the
batteries
1. Prepare a new AAA alkaline battery.
2. Press the button at the back of the mouse, and then remove the cover.
3. Please identify the right side of the battery’s polarity and insert the
battery.
4. Put back the top cover. You will hear snap sound once the cover is
properly installed.
Install the receiver and establish data connection
1. Remove the receiver from the bottom of the mouse, and plug it into
available USB port of your computer.
2. System will detect and install new hardware automatically.
3. Once the installation is ready system shall show message that the de-
vice is ready to be used.
DPI Switch buttons
By default DPI value is 1600 DPI. You can switch the DPI mode by press-
ing the DPI switch on the bottom of the mouse
Use on different surfaces
MC-C1W should be able to work correctly on most surfaces, except the
transparent glass.
Low voltage indicator
At the top of the mouse there is low-voltage LED which is lit if the battery
voltage is lower than ~1.1V voltage. This is to inform you that battery
replacement might be needed soon.