65
d) Checking and Setting the Neutral Servo Settings
Prior to programming the remote control system or adjusting your model, you have to make sue that the digital trimming
for the steering and drive function is in the central position.
Each brief push of the programming and setup buttons is confirmed with a tone/sound signal. The tone
signal can also be deactivated, see chapter 12. q).
• You can use the "ST.TRIM" rocker button (see fig 1, pos 2), to set the central position
for the steering servo (CH1).
• You can use the "TH.TRIM" rocker button (see fig 1, pos 6), to set the central position
for the gas servo or the neutral setting for a drive control unit (CH2).
Figure 13
ST.TRIM
TH.TRIM
Summary of Contents for 20 72 54
Page 200: ...198 ...
Page 201: ...199 ...
