70
d) Function "4:REV", Servo-Reverse
Depending on the position of installation and the steering in the model, it can
be necessary to change the turning direction of the servo or to reverse the
reaction of the drive control unit to lever movements.
If you turn the steering wheel on the transmitter (see fig 1, pos 4) to the left, but
the vehicle steers to the right, you must activate the Reverse function for Channel
1 ("ST").
Settings can be made for the steering servo ("ST") and the gas servo/drive
control unit ("TH") and the third channel ("AUX").
Proceed as follows:
• From within the main menu (see fig. 5) press the "ENTER" button, then you
can use the "+" or "-" buttons to select the "4:REV" function (fig 22).
• Then press the "ENTER" button again to reach the settings menu (fig 23).
• You can use the "ENTER" button to switch between "ST", "TH" and "AUX".
• The turning direction can be adjusted ("NOR" = Normal, "REV" = Reverse)
by pressing the "+" and "-" buttons.
• Exit the settings menu with the "EXIT" button, the settings are automatically
saved.
Please note:
If the turning direction is reversed, the sub-trim settings change to the other side also (see chapter 12.
c).
Function11.2V
1:EPA
2:D/R
3:S_TRIM
4:REV
Figure 22
REVERSE 11.2V
REV
NOR
ST
TH AUX
Figure 23
Summary of Contents for 20 72 54
Page 200: ...198 ...
Page 201: ...199 ...
