78
h) Function "8:MODEL", Model Memory
The remote control has a total of 16 model memories. This allows you to operate
up to 16 vehicle models.
Please note that one receiver can only be registered to a single model
memory.
If you are using several vehicles with an integrated receiver each, assign e.g.
receiver/vehicle 1 to memory 1, receiver/vehicle 2 to memory 2 etc.
If – for reasons of expense – you only use one receiver for several vehicles,
the receiver has to be registered to the transmitter again after switching the
model memory, see chapter 12. k).
Of course, the same applies if you intend to use several different setups (or
model memories) for a single vehicle.
1. Selecting a Model Memory
• From within the main menu (see fig. 5) press the "ENTER" button, then you
can use the "+" or "-" buttons to select the "8:MODEL" function (fig 53).
• Then press the "ENTER" button again to reach the model menu (fig 54).
• Use the "+" or "-" buttons to select the "SEL" function (see fig 54).
"SEL" = Select a model memory
"EDT" = Edit a model memory
"CPY" = Copy a model memory
• Then press the "ENTER" button, the model name will be bordered in black,
see fig 55 ("Mod01").
• The desired model memory can be selected (0 to 15) by pressing the "+" and
"-" buttons.
• Then press the "ENTER" button again to return to the model menu (fig 54).
• You can exit the model menu by pressing "EXIT".
The delivered product has the model memories with names preset from "Mod00" to "Mod15". Of course
these names can be change, as described in the following section.
MODEL 11.2V
MDL.N: Mod00
SEL
EDT CPY
Function11.2V
5:ST CURV
6:TH CURV
7:ABS
8:MODEL
Figure 54
Figure 53
MODEL 11.2V
MDL.N:
Mod01
SEL
EDT CPY
Figure 55
Summary of Contents for 20 72 54
Page 200: ...198 ...
Page 201: ...199 ...
