79
2. Changing the Model Memory Name
• From within the main menu (see fig. 5) press the "ENTER" button, then you
can use the "+" or "-" buttons to select the "8:MODEL" function (fig 53).
• Then press the "ENTER" button again to reach the model menu (fig 56).
• Use the "+" or "-" buttons to select the "EDT" function (see fig 57).
"SEL" = Select a model memory
"EDT" = Edit a model memory
"CPY" = Copy a model memory
• Press the "ENTER" button, a matrix of all available numbers and letters will
appear (0...9, A...Z), see fig 58.
Proceed as follows to enter a name:
Use the "+" and "-" buttons to select a letter or number (for quick adjustment
hold down the button).
On the far right at the bottom of the matrix you will see the "space".
You can use the "ENTER" button to move to the next letter to be entered.
To delete a letter or number select "
" and press "ENTER".
To change between small and capital letters. select "
" and press "ENTER"
(it is possible that this will not function with this version of the remote control).
To complete the input and to save the name, select " " and press "ENTER".
The remote control is then back in the model menu (fig 56).
• The "EXIT" button interrupts changing/inputting the name and returns the
remote control to the model menu (fig 56). The previous name of the model
memory is not changed.
Figure 57
MODEL 11.2V
MDL.N: Mod00
SEL
EDT
CPY
MODEL 11.2V
MDL.N: Mod00
SEL
EDT CPY
Figure 56
MDL.N:
0
1 2 3 4 5 6 7 8 9
A B C D E F G H
I J K L M N O P Q
R S T U V W X Y Z
Figure 58
Summary of Contents for 20 72 54
Page 200: ...198 ...
Page 201: ...199 ...
