91
r) Function "18:RESET", Reset Transmitter to Factory Settings
This function allows the transmitter to be reset to the factory settings.
Please note:
This deletes all the data programmed by you, all model memories
will be deleted, the names of the model memories will also be
reset.
The transmitter is then reset to the same status as at its first
operation.
It is not possible to restore the deleted data, you need to carry
out the programming again.
Proceed as follows:
• From within the main menu (see fig. 5) press the "ENTER" button, then you
can use the "+" or "-" buttons to select the "18:RESET" function (fig 91).
• Then press the "ENTER" button again to reach the settings menu (fig 92).
If you do not wish to carry out the reset, with the "EXIT" button you can return
to the main menu.
• Press the "ENTER" button to carry out a reset. Then the transmitter begins
to reset all programmed data (see fig 93).
This process takes approx. 30 seconds, then the transmitter emits a tone
signal.
All model memories are now empty or returned to the factory settings.
• You can exit the settings menu by pressing "EXIT".
Function11.2V
17:SOUND
18:RESET
19:M_RES
20:TIMER
Figure 91
RESET 11.2V
Reset System?
RESET 11.2V
Reseting....
Figure 92
Figure 93
Summary of Contents for 20 72 54
Page 200: ...198 ...
Page 201: ...199 ...
