32
15. Modifying the Transmitter ID
Your transmitter has a fixed ID at delivery. This ID is a digital code for encrypting the transmitter signals.
Should you need to change this code, proceed as follows:
• Keep the “PDM” button pressed and turn on the transmitter.
• The red LED flashes thrice quickly, then both LEDs will flash alternatingly.
• Press the “PDM” button. A new ID is generated and the green LED flashes quickly thrice.
• The new ID will only become active when the transmitter is switched off and on again
Remember that your receiver has to be bound to the transmitter again after the ID was changed! (See
chapter 14).
16. Transmitter Conversion
If you want to exchange the two control lever functions “Motor speed” and “Elevator”, you have the possibility of
adjusting the reset spring and the stop spring of the control lever unit in the transmitter accordingly.
Afterwards, you just need to swap the connectors for the elevator and motor control at the receiver.
Doing this, however, requires some experience in handling remote controls. If you do not have this experience, you
can send the transmitter to our customer service department to be modified.
17. Maintenance and Care
Clean the exterior of the remote control only with a soft, dry cloth or brush. Never use any aggressive cleaning agents
or chemical solutions that may damage the surface of the housing.
