66
Programming via the control elements:
Switch the transmitter on.
To switch into the programming mode and to end it again, press the [Menu] and [Sel] buttons
simultaneously.
The Main Menu for Helicopter Models will be displayed.
Using the „Menu“ button, scroll through the items of the main menu to the parameter you want to change.
Each press of the button will cause the following menu items to appear one after the other on the display
(default setting for helicopter models):
1. T Cuv (Throttle Curve)
2. EP (End-Point Adjustment)
3. DR (Dual Rate)
4. P Cuv (Pitch Curve)
5. AFR (Adjustable Function Rate)
6. REV (Reverse)
7. SUB (Subtrim)
8. TYPE (When a helicopter model has been pre-selected, you can select here directly between 1 = Heli-120,
2 = Heli-90 & 3 = Heli-140.)
The menu items [EP], [DR], [REV] and [SUB] correspond exactly in function and programming
to those described in the section „Setting the Main Menu Items (Winged Models)“.
You can program all the main menu items available one after the other, without leaving the
programming mode intermittently.
To leave the programming mode, again press the [Menu] and [Sel] buttons simultaneously.
The settings selected are immediately activated and can be observed directly by the reaction of
the respective servo.
To make optimum use of programming via the software, for some functions you first have to
activate one or both toggle switches and/or the rotary controller on the transmitter, and allocate
the respective function to the switch/rotary controller.
This can only be done via the software.
Summary of Contents for 206501
Page 178: ...178 ...
Page 179: ...179 ...
