English 27
-
Put / insert oven int o the kitchen set hole by installing a screw type A int o the four holes in t he oven.
Screws can be found on the side of the oven frame.
-
Connect the power cord plug to the wall outlet and the oven is ready to use.
-
For the most efficient air circulation, the oven must be installed i n accordanc e with the dimensions
shown in Figure 1-2.Panel rear of the cabinet must be removed so that air can circulate freely. Panel that
install on the oven must have a gap of at least 70 mm at the rear.
Electrical Connections
Oven is equipped with a three-pole power cord designed to operatewit h alternating current at the voltage and
frequency that written on the table of specifications .
Connect the board power supply cord to the power
Fit a standard plug in accordance with the load shown in the table of specific ations.
The unit must be directly connected to the electricity using omnipolar s witch with opening contact of at least
3 mm installed between the appliance and the electricity.
The switch must be suitable for the load indicated on the label and must comply with the regulation of
electrical currents (eart hing wire must not be interrupted by the s witch). Power supply cord should be
positioned so it does not contact with the higher temperature of 50 ° C at any point.
Make sure that the correct electrical connection has been made and is fully compliant with safety regulations.
Before the appliance connect to a power sourc e, ensure that:
-
Earthing / grounded the unit and use a plug in accordance with the applicable regulations.
-
Electric socket can withstand with t he tool maximum power, which is indicated on the data label (see
below).
-
Voltage in the range between the values indicated on the data label (see below).
-
The electric socket is compatible with t he plug of the appliance. If the socket is incompatible with the
plug, ask the technician to replace it. Do not use extension cords or multiple electric socket.
-
After mounted the unit, power supply wiring and outlet should be easily accessible.
-
Cables must not be bent or crushed.
-
Cable must be checked regularly and replaced only by an official technician.
-
The manufacture disclaims any duty which should, if this safety measures are ignored.
Pic . 2
Pic . 1