English 38
-
Frequentely check the gas hose, to make sure t hat gas hos e is far from hot surface, and not in bent
position. Make sure the outer surface of hose isn’t cracked so that can be a leakage.
-
When you smell gas, immediately realese the regulator from the gas tank and immediately.
-
Do the routine service on your built-in oven every 3 (three) month, because if the is something wrong
on your B uilt-in oven, you can immediately detect and repair.
C
C
h
h
a
a
n
n
g
g
e
e
t
t
h
h
e
e
O
O
v
v
e
e
n
n
l
l
i
i
g
g
h
h
t
t
-
Disconnect the oven from the power supply, either by pulling the plug
out or by switching off the power supply at the mains;
-
Remove the protection glass (A) and replace the burnt out bulb with
one of the same type
-
Replace the burnt out bulb with one of the same type
.
-
Installed the cover protection “A”.
R
R
e
e
m
m
o
o
v
v
a
a
l
l
o
o
f
f
O
O
v
v
e
e
n
n
D
D
o
o
o
o
r
r
To water down in cleaning oven, door oven earn released by :
-
To mak e cleaning easier, remove the oven door as
follows: insert hook A (fig. beside) in hing e slot B.
-
Half open the door and, using both hands, pull the door
towards you until it becomes unhooked.
-
To refit the door, carry out the same operation in reverse,
taking care to introduce the two sectors C correctly.
Clean the glass with a sponge and cleaning products are non-abrasive, then dry wit h a soft cloth. Do not use
materials that are abrasive or have sharp surfaces as it can scratch the surface and cause the glass to
crack.
Inspect the seal
.
Check the seals around the doors on a regular basis. If the seal is damaged, contact the service center
MODE NA for repair or replacement. It is advisable not to use the oven for separately seals have not been
replaced or repaired.
Installation sliding rack / "sliding rack kit"
(
for selected models).
To install sliding racks:
1) Remove the t wo frame, with the lifting of the spacer A (see Pict. 1).
2) Choose where you want to install the rack sliding shelves. Pay attention
to the direction of t he sliding shelf which should be extracted (see the
orientation B and C in order). (see Pict.2).
