English
19
-
If the bathroom is too small, the heater can be installed at another place. However, in order
to
reduce the pipeline heat losses, the installation position of the heater shall be closed to
the
location shall be as near as possible to the heater.
3.2 Pipelines Connection
-
The dimension of each pipe part is G1/2 (
”BSP ½”) ; The massive pressure of inlet should use Pa
(Bar) as the unit; The minimum pressure of inlet should use Pa (Bar) as the unit.
-
Connection of pressure relief valve with the heater on the inlet of the water heater.
-
In order to avoid leakage when connecting the pipelines, the rubber seal gaskets provided with
the heater must be added at the end of the threads to ensure leak proof joints (see Diagram 9).
-
If the users want to realize a multi-way supply system, refer to the method shown in Diagram 10
for connection of the pipelines.
