5
Installation Instruction
The installation for the plumbing and the electrical wiring must be
done by qualified technicians, according to the installation
instructions and in compliance to the local authority regulations.
This water heater must be installed as near as possible to the
usage stand-point to reduce the heat loss along the pipes. To
facilitate maintenance process, make 50 cm distance for the easy-
access of the electrical parts.
This water heater should be installed on a solid cement wall and
close to the power and the water source.
Use only the accessories provided in the wrapping box to install
this electric storage water heater.
Before determining the bolt holes position, ensure that the water
heater position is more than 200 mm from the floor or ceiling board
in order to facilitate maintenance process when necessary.
After selecting the proper position of installation, use the anchor
bolt to secure the hanging board firmly (see the picture below),
and then install the appliance.
MODENA
is not responsible for any improper installation and
incorrect operation of this appliance due to the failure of user in
following the instructions in this manual book.
NOTE
The button functions on the remote control are same as on the
water heater.
PART 3: INSTALLATION
