6
After selecting a proper location, determine the position of two
holes that are used for the installation of the expansion bolts with
hook. Make two holes on the wall by using a chopping bit with the
depth matching to the size of the expansion bolts that attached
with the water heater. Then, insert the bolts, turn the hook
upwards, tighten the nuts to fix firmly, and then hang the water
heater on it.
Install the power socket in the wall. The requirements for the power
socket are as follows: 250V/10A, single phase, and three
electrodes. It is recommended to place the power socket on the
top right of the water heater. The height of the socket to the
ground shall not be less than 1.8 m.
If the bathroom is too small, the water heater can be installed at
another place outside the bathroom. However, in order to reduce the
heat loss caused by long pipeline, the installation position should be
as near as possible to the bathroom.
Expansion bolt with
hook
Ground
≥1.8 m
N (Blue)
E (Yellow/Green)
L (Brown)
